Square Boom Clip Holder

This clip holder mounts to a square boom using a ratchet tie down. This clip holder will hold the round tube of your hydraulic chain saw or pruner and can be used in conjunction with AC6212 or AC6213. You can quickly place your pruner in the clip holder while completing other tasks until you need to use it again.

The clip holder measures 5-3/4 inch wide, 3-1/2 inch

deep.

Average Customer Review: Average Customer Review: 5 of 5

5 of 5 Total Reviews: 2 Write a review.

0 of 0 people found the following review helpful:

	September 28, 2020
Reviewer: Tom Chicoine from Southampton, MA United States

Was this review helpful to you?

1 of 1 people found the following review helpful:

	November 5, 2018
Reviewer: Jose Cortes from Fort Worth , TX United States

Was this review helpful to you?

	Spiral Hex BTA Pilot Bit C30 Teeth $655.00
	Terex Bearing Cone- Texoma 330 $1,907.75
	48" Digger Derrick Spin Bottom Cleanout $9,995.00
	12" Bullet Tooth Rock Auger with 3" Square Kelly Box $3,330.00
	18" Interchangeable TXC Series Head $1,175.00
	Terex Digger Derrick Auger Shank Plate 48" $448.00
	20" Interchangeable Bullet Tooth Head $2,250.00
	Terex Shim Set- Texoma 330 $196.18
	Greenlee Submersible 2" Water Pump $2,113.69