Square Boom Saw Holder

This chain saw holder mounts to a square boom using a ratchet tie down. This chain saw holder will hold the blade end of your hydraulic chain saw and is used in conjunction with AC6211. You can quickly place your chain saw in the clip holder while completing other tasks until you need to use it again.

The chain saw holder measures 4 inch wide, by 6 inch long, by 1-1/2 inch deep.

Average Customer Review: Average Customer Review: 5 of 5

5 of 5 Total Reviews: 1 Write a review.

1 of 1 people found the following review helpful:

	Monday, November 5, 2018
Reviewer: Jose Cortes from Fort Worth , TX United States

Was this review helpful to you?

	42" Bullet Tooth Rock Auger with a 4" Square Kelly Box $8,925.00
	24" Digger Derrick Dirt Auger $1,875.00
	ESC35LX11 Cable Cutter $2,929.00
	Reliable Chainsaw Drive Shaft $179.00
	Greenlee Motor Cap for Long Reach HA, AM, FR Series Chainsaws and 2" Water Pump $216.60
	Reliable Tamper Control Valve Assembly $260.00
	Terex 330 Upper Packing Set- Upper Feed Ram $124.50
	Kelly Bar Adapter 4" Box to a 4" Bar 36" Bar Length $1,389.00
	Seal Kit for Emerson-Greenlee Ground Rod Drivers and Post Drivers $236.65