Home > Auger Accessories > Digger Derrick Kelly Bars & Extensions >

2 5/8 inch hex by 72 inch kelly bar

Terex 2 5/8" By 72" Bar
 
Our Price: $382.71

Availability: Usually ships in 4 to 5 days
Product Code: T80599
Qty:

Description
 
Texoma kelly bar for digger derrick augers. These can be used to replace a damaged or missing hex shaft. This bar is 2 5/8 inch hex and 72 inches long and has holes predrilled at 12 inch increments. To be used with either a split bolt together or double female hex coupling to attach to the auger drill motor as it has no hex coupler.
Features
2 5/8 inch hex bar 72 inches long with holes every 12 inches. Goes inside the auger tube and telescopes out to drill deeper. Used to connect the auger and the drill motor. Can also be used with correct attachments to install anchor screws.
Does not have a hex coupler.

Average Customer Review: 3 of 5 Total Reviews: 1 Write a review.

  0 of 0 people found the following review helpful:
 
terex kelly bar May 26, 2017
Reviewer: mitch from Canada  
I'm use to the Belltec Hex Bar extensions but i'm not seeing much difference.  I did not notice any real difference from the so called Heat Treated Alloys Belltec uses though.  Product is holding up well.  I I can find them a bit cheaper I will start using these rather then cheaper products from China.

Was this review helpful to you?